Assuming
President Bush is not impeached, here is how you reset your Countdown
Clock for when President Obama is inaugurated on January 20,
2009.
1. Press the MODE2 button once. Press the
SET button once and the digits representing the year will flash.
Set it to 2009. You may adjust the year by pressing the SET button.
2. Once the year has been set, press the MODE2 button to select
the month (January) which you can adjust by pressing the SET button.
3. Follow the same procedure (using the MODE2 button to select
and the SET button to adjust) for setting the day (20th).
4. Finally, press the MODE2 button to return to the countdown
display which shows the number of days, hours, minutes and seconds
remaining to that magical date when we will no longer be under
the Bush regime, as well as the current time.
1. Press the SET button once. Press the
M1 button once and the digits representing the year will flash.
Set it to current year. You may adjust the year by pressing the
SET button.
2. Once the year has been set, press the M1 button to select the
month which you can adjust by pressing the SET button.
3. Follow the same procedure (using the M1 button to select and
the SET button to adjust) for setting the day .
4. Press M1 again and the hours will be flashing. Press the SET
button to set the correct time, press M1 again to switch to the
minutes. Press set until correct time is displayed. Press M1 again
to set AM/PM. The SET button switches between them.
5. Finally, press the M1 button to return to the countdown display
which shows the number of days, hours, minutes and seconds remaining
to that magical date when we will no longer be under the Bush
regime, as well as the current time.
|
Your Countdown
Clock is powered by a battery which should last for several years.
However, if battery replacement is required (the Countdown Clock's
display will be blank), simply open the battery compartment located
on the bottom of the clock. Remove the old battery and replace
it, making sure that the + side of the battery is positioned as
indicated.
1. Using a small Philips head screwdriver, remove
the two small screws that secure the back plate of the clock.
2. Carefully remove the dead battery and replace it with a 3-volt
lithium cell (Sony CR2025, Panasonic BR2025, Eveready ECR2025
or equivalent lithium battery designated as a 2025).
3. Reposition the back plate and secure with screws.
4. Reset your Countdown Clock (see instructions above). |
